Motions & Forces

Din lead intended for use with the Unilab Master Light Gate (B8L86356).

Glass Displacement Vessel with spout, for displacement / specific gravity experiments.  Capacity: 500 ml

Small Displacement Vessel made from mild steel with overflow, for displacement and specific gravity experiments. Dimensions:115mm x 50mm approx. A larger size is also

Double Pulley BlockIncorporating 50mm diameter plastic pulleys carried in tough plastic frames. These blocks are available in double and triple

Metal Dynamics trolley of compact design.  One end of metal body carries an integral spring plunger / trigger system for explosion experiments whilst the other

Coils open at 20g load and extend to approximately 60mm at 100g load.Max. extension without permanent deformation is approximately 150mm.Dimensions of coiled

The Falling Bodies Apparatus demonstrates the effect of gravity on falling bodies.The L-section launcher has holes for locating two 19 mm diameter steel balls which act

The Unilab Fast Timer is a versatile, portable instrument for timing brief events with two ranges: 1 to 999.9ms and 1 to 9999µs. The inputs can be controlled by light

Foundation Physics - Collision Carts<em><strong>Please Note: The Foundation Physics Universal Stand and the Inclined Plane are not included with the Collision

Foundation Physics - 'g' by Free Fall Apparatus&nbsp;<em>< strong>Please Note: The Foundation Physics Universal Stand is also required but is not included and will need to

Foundation Physics - Stopped Pendulum<em><strong>Please Note: The Foundation Physics Universal Stand and Pendulum board are not included and will need to be purchased

The Foundation Physics Constant Motion Cart enables the investigation of the concept of constant velocity and acceleration.&nbsp; When in motion, the Constant Motion

The Unilab 'g' by Freefall Ball (g-Ball) is a fun way to measure the acceleration due to gravity and make empirical measurements to illustrate the laws of motion. The g-Ball

g' by Free Fall Apparatus by LascellsUse in conjunction with an accurate millisecond timer to calculate acceleration due to gravity. The timer starts when the ball

Plastic end cap for 100ml Glass Gas Syringes (B8A36171). Supplied in a pack of 10.

This demonstration of the Gauss gun effect uses a 660mm long section of acrylic tube to house rare earth magnets and ball bearings. One end is raised slightly to allow the

Glass tube is 50cm (20") long and 26mm diameter with two rubber bungs, one carrying brass, and 40cm long pressure rubber tubing to connect to a vacuum pump.

This gyroscope is mounted on a gimbal cradle. A solid block and a rocker are supplied for supporting the gimbal cradle. The sturdy gyroscope has a brass rotor, 6cm in diameter.

To determine the value of 'g' by timing the fall of a steel ball.The release unit consists of a plate (90mm x 45mm x 3mm) carrying a pair of metal clips connected to 4mm sockets. The

Palm-sized, hollow metallic ball with a manometer connected to it for demonstrating change of pressure in a closed volume of air when heated or cooled.

Large Displacement Vessel made from mild steel with overflow, for specific gravity experiments. Dimensions: 225mm x 125mm approx. A smaller size is also available.&nbsp; As is

Supplied as a kit for eight pupils and consists of five MDF beams (600mm x 44mm x 3mm) graduated every 38mm and with a groove across its centre to locate the fulcrum point.Also

TSA Light Bridge&nbsp;The low current Light Bridge connects directly to the DIN sockets on the TSA enabling velocities and accelerations to be displayed. There are no

For connection to Motion QED only. As per the Unilab Slave Light Gate (B8H27623) except both power and signal are carried by a single DIN lead. A further DIN lead connects